Module 5: Introduction to SquareWear

Module 5: Introduction to SquareWear

Goal of this Module: Introduce students to the basics of SquareWear
Module 5: Introduction to SquareWear Document Download
Module: Introduction to SquareWear

SquareWear Kit: 

breadboard
jumper wires
LEDs RYBG
3 volt battery
coin holder
button

Lesson

Driver for SquareWear Mac Free Download 
 Driver for SquareWear Windows Free Download
Arduino Software Free Download  





Setup
  
 

 
Upload Sample Code
  


Edit the code
 

 
int redLED = 8;
int blueLED = 13;
int greenLED = 12;

// the setup routine runs once when you press reset:
void setup() {             
  // initialize the digital pin as an output.
  pinMode(redLED, OUTPUT);  
  pinMode(blueLED, OUTPUT);
  pinMode(greenLED, OUTPUT);
}
// the loop routine runs over and over again forever:
void loop() {
  digitalWrite(redLED, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);            // wait for a second
  digitalWrite(redLED, LOW);  // turn the LED off by making the voltage LOW
  delay(1000);

  digitalWrite(blueLED, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);            // wait for a second
  digitalWrite(blueLED, LOW); // turn the LED off by making the voltage LOW
  delay(1000);  

  digitalWrite(greenLED, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);            // wait for a second
  digitalWrite(greenLED, LOW);  // turn the LED off by making the voltage LOW
  delay(1000);  // wait for a second
}
  
Clean up the Code
 


int LEDs[] = {8,13,12}; // array of LED pins
int numLEDs = 3; // number of LED pins

// the setup routine runs once when you press reset:
void setup() {             
  // initialize each digital pin as an output.
  for ( int i = 0; i < numLEDs; i++ )
     pinMode(LEDs[i], OUTPUT);  
}
// the loop routine runs over and over again forever:
void loop() {
  // make each LED flash
  for ( int i = 0; i < numLEDs; i++ )
  {
     digitalWrite(LEDs[i], HIGH);  // turn the LED on 
     delay(1000);             // wait for a second
     digitalWrite(LEDs[i], LOW);  // turn the LED off 
     delay(1000);                // wait for a second
  }
}
  
Write Your Own Code
 
  Find RGB values Site


Get to Know SquareWear Further
 


Use the Photoresistor
 


Use the Temperature Sensor
 


Modify the Temperator Sensor Sketch
 


Use the Buzzer
 


Make Your Own Sketch